MÁY Water Softener Cabinet12"W x 21"D x 45"H (cabinet Compact Unit, 1.0CuFt of Resin)



Residential Water Softener

Eliminates limescale, soapcurd and reduces Soap/Detergent use up to 70%.


Ion Exchange For Hardness Mineral Removal
Uses Purolite 40-70 Mesh Resin For Low Salt Use And Minimum Brine Discharge
Metered Demand Regeneration Meets California Requirements
1.0 Cu. Ft. Resin Capacity
Compact Cabinet Configuration
Proven Fleck Valve Provides Reliable Control

Softening Is A 4-Step Process
1. The water softener tank is filled with small diameter resin beads which are covered with sodium ions. When hard water flows through the resin bed, the beads act like a magnet, attracting the calcium and magnesium ions in the water in exchange for the sodium ions.
2. Eventually the resin beads become saturated with the hardness mineral ions and must be ‘re-charged”. This regeneration process is conducted by the control valve on the top of the tank. The control valve is the brain of the system.
3. During regeneration, a strong brine solution from the brine tank is flushed through the resin tank, bathing the resin beads in a stream of sodium ions from the salt in the brine. This replaces the calcium and magnesium ions captured by the resin beads.
4. The brine solution carrying the displaced hardness minerals is flushed to the drain with fresh water. The resin beads can be used over again.
Choosing The Correct Size Softener

To choose the softener with the correct capacity, water usageand water hardness must be determined. Water usage can be obtained from a water bill, or use the estimated 100 gallons per person per day average for most US citizens. Water hardness information can often be obtained from the local water company. Water should be tested in a well water system, or when the local municipal water information is unavailable. Use Vertex Hardness Testing Strips for quick onsite testing, or contact an independent lab through the Water Quality Association (WQA) or local Department of Health.

An average family uses 100 gal./day of water per person. A household of four needs 400 gal/day of softened water. If the water has a hardness of 20 grains per gallon, 8000 grains have to be removed per day (400 gal. X 20 grains/gal.) With regeneration every 3-days, the minimum softener capacity should be 24,000 grains (8000 grains/day x 3 days). A 1.0 cu. Ft. softener model can remove 30,000 grains and would be the right choice.

Hardness conversion
Hardness is measured in grains per gallon (GPG). Most often the published municipal water information is in part per million (PPM). Determine the GPP by using the equation:

PPM ÷ 17 = Grains per Gallon (GPG)

Download a Brochure.  

Hardness Removal - 30,000 grains


Softener Specifications
 Applications for limited 
 Nominal Resin Capacity 1.0 Cu. Ft.
 Nominal System Flow
 @50 psi, 15 psig drop
9.5 gpm
 Hardness Removal - grains 30,000
 Softener Tank SIze 12"W x 21"D x 45"H
 Brine Tank Size
 Type Control Valve Fleck 5600SE
 Power Supply 24VAC
incl. trans.
 Pipe Sizes inlet 3/4 or 1”
drain, 1/2”
 Weight, Pounds 85
 Overall Dimensions Height: 45”, Width: 12”
FaLang translation system by Faboba